You can adjust the tone depending on where you post it. Understanding the Register Code Generated by Image2LCD (Bitmaps to MCU Display)
// Example: Sending register code from Image2LCD void LCD_Send_Init_Sequence(uint8_t *cmd_list, uint8_t len) { for (int i = 0; i < len; i++) { uint8_t cmd = cmd_list[i++]; uint8_t data = cmd_list[i]; LCD_Write_Command(cmd); // Pull RS low (CMD) LCD_Write_Data(data); // Pull RS high (DATA) delay_ms(5); // Some registers need settling time } } image2lcd register code
I’ve been working with small TFT or monochrome LCDs (like ILI9341, ST7789, or SSD1306) and using to convert bitmap images into C-style arrays. However, the "register code" it generates can be confusing if you're not sure how to interface it with your MCU's driver. You can adjust the tone depending on where you post it
// Your Image2LCD generated list const uint8_t init_code[] = { 0x01,0x00, 0x11,0x00, 0x3A,0x55, 0x29,0x00 }; // Your Image2LCD generated list const uint8_t init_code[]
void setup() { LCD_Init_Pins(); LCD_Send_Init_Sequence(init_code, sizeof(init_code));